Wednesday, February 12, 2014

Science Behind Crown Molding Angles



man's hand holding crown molding
Getting the perfect angle with the Cut N Crown system.

So You Want To Install Crown Molding

As if the task of installing crown molding wasn't enough, there is also a tricky process of getting the angles right! Don’t feel disheartened, if in the past, you have wasted a frightening amount of expensive crown molding trying to get the angle right. It may seem like a very daunting process that requires lot of precision. However a little patience and knowledge can go a long way in getting the angles right. 

A Little Help

Below are some tips that will get your confidence back when you have lost all hope of getting that perfect crown molding angle. Before applying these methods keep in mind that not all walls and ceilings are plumb and level. However, this is not a problem when using Cut N Crown system.


  •  Always buy a few extra pieces when you are shopping for crown molding. You won't want want to fall short of materials in the middle of the project
  • Don’t waste your time with a generic miter box. That's what the Cut N Crown jigs are for. Grab a miter saw that performs all the tasks at greater precision, and that is easy to store and carry.
  • Read the instruction manual thoroughly for your saw. It will need to be adjusted to the angles you will measure.
  • Measurements will be taken with the angle finder supplied in the Cut N Crown kit.
  • Be extremely accurate when marking your pieces. It will save you from wasting molding pieces due to human error.
  • The next step is using the jigs, included in the kit, to cut your molding at the perfect angle.
  • It is highly recommended that you use a nail gun during installation to avoid splintering. Try to hit a stud when possible for the most secure hold.
  •  If you have to use more than one piece of molding on the length of the wall, don’t cut them in a straight line. Make beveled cuts to make the seams appear neater.

That's A Wrap!

These simple steps can make installing crown molding a far less daunting task. Don’t be discouraged with the work that it entails. All you need is patience and the Cut N Crown system to aid you in this DIY project you've always dreamed about.

If you need more information or tips using the Cut N Crown system, please visit our website to access how-to videos on installing crown molding.  

No comments:

Post a Comment